Elipse Scada Hardkey 140: The Ultimate Solution for Your Industrial Automation Needs

312 GE HEALTHCAREDRAFT Section 8-13 Replacement of the Caps for Hardkeys NOTICE Please observe that replacement procedure depend on key caps that have to be replaced! if just the circle key caps have to be replaced. if trackball buttons or mode key slices have to be replaced too, please contact your local distributor or GE service representative Replacement of Circle Key Caps only Manpower One person, approx. 1 minute/cap Tools Small-sized slotted screwdriver or tweezers Circle Key Caps - Replacement Procedure 1.) By means of a small slotted screwdriver, carefully push against the circle hardkey cap. 2.) Lift the cap, until it is completely loosened from its base. 3.) Place the new hardkey cap down until it snaps into position. Figure 8-23 Push against the circle cap and lift it Chapter 8 - Replacement Procedures 8-23

Elipse Scada Hardkey 140

Download Zip: https://urluss.com/2vBBgd

2ff7e9595c